TL1000R

Veypor installation is dead easy on the TL (Click here for the manual). Firstly, flash your Veypor to the latest firmware, old versions do not like the power drained by a big twin's starter motor.

Remove the seat and connect the ignition coil sensor to the white wire coming out of the ECU unit.

Ground the Veypor wherever you like and connect the red power wire to the ignition power from the ecu (on my way to check colour).

I've glued the wheel magnet to the rear disk and cable tied the sensor to the back of the swinging arm.

I used the following figures to set up the Veypor.

Weight - 666 lbs

RPM Multi - 7

Wheel Circ - 770 (190 rear section)

Pictures to come.